Graph-tech Ghost Manual de usuario descargar pdf (Pagina 36)

Using a 1/16” bit, drill the four holes for the mounting screws

in the outer most marks to a depth of 1/4”. Make these holes

perpendicular to the surface. Using a 1/8” bit, drill the inner

four marks to a depth of 1-1/8”, dening the four corners

of the mounting hole. Drill these holes parallel to each

other; in other words don’t drill them perpendicular to the

surface, as this will make the cavity narrower towards the

bottom, preventing the 13-pin board from tting properly.

90°

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 75 76

Sin comentarios

Graph-tech Ghost Manual de usuario Pagina 36